For Turbo200X Wiring Instructions Click Here

Turbo 200 Wiring Installation Instructions

55 + 7.5 MFD

Note: Not all installations have two (2) wires connected to the common as shown in the dual-value illustrated examples. In some installations there is only one (1) wire which is common to the compressor and fan motor.

EXAMPLE: To replace a 55 + 7.5
microfarad Dual-Value Capacitor: BEFORE YOU START: Make note of the wires which
are attached to the fan motor (F), common (C), and compressor (Herm) terminals
of the capacitor being replaced. STEP 1: To achieve the 55 microfarad for the
compressor (HERM) - using two (2) jumper wires (a) connect the 10 + 20, then
(b) connect 20 +  25, This will equal 55.0
microfarads. Connect one of the wires from the compressor to the 25 MFD
terminal. STEP 2: Connect the other wire(s) from the compressor to the common
(C). [The common is the center black terminal]. STEP 3:  Using one(1) jumper wire, connect the 5 (4) +
2.5 (3.0).  This will equal 7.5
microfarads.  STEP 4: Connect one of the
fan wires to the 5 (4) mfd terminal. STEP 5: Connect the other wire from the
fan motor to the common (C). [The common is the center black terminal].